image

ALevel

Biology-9700

Transport Mechanism

Paper-2

Transport Mechanism

Multicellular organisms need a transport system as the distance between the cell and surface is large. Thus, diffusion alone cannot allow transport.


Transport In Plants:

Plants need to transport two substances.

Transport of water from the soil to leaves.
Transport of solutes from leaves to other cells.

Transport Of Water

The transport of water can be divided into various steps.

The first is transported from soil to root hairs.

1. Then, from root hairs to the xylem.
2. Finally from xylem to leaves.

Transport From Soil To Root Hairs:

The primary root is covered by a cap called root cap this makes it impermeable for the absorption of water and other substances.

To overcome this, the epidermis sends out fine branches called root hairs. These root hairs are involved in the absorption of substances. They also increase the surface area for absorption.

Absorption Of Water Down The Concentration Gradient:

The soil has high water potential than root hairs. It contains solutes and other ions but the solution is dilute.

In contrast, the cell has a high concentration of ions in cell sap making it at low water potential.

Thus, water is easily transported from soil to root hairs across the concentration gradient.

Transport From Root To Xylem:

Now, the water has to be transported from roots to the xylem.

The figure shows a cross-section of the root. Water has to be transported first from root hairs to cortex than it enters the stele where xylem is located.

Water potential in the xylem is at low water potential than the root hairs thus the water can easily move through it.  

There are two routes that water takes to enter the xylem.

Routes Taken By Water:


1) Symplast

Symplast is the movement of water from one cell to another cell. The water enters the cytoplasm than the cell sap of one cell than to others.

2) Apoplast

Movement of water from the cell wall to cell wall without entering the cytoplasm is called the apoplast pathway.

Water can take any of the two pathways to cross the cortex and reach the stele.

Movement From Stele To Xylem:

Once the water has reached stele now the apoplast pathway is stopped. This is because the endodermis is surrounded by a waxy layer called the Casparian strip. This layer is impermeable to water.

Thus, water can move only by the symplast pathway.

Movement Of Water From Leave To Atmosphere:


Transpiration

The leaf has a layer of cells called spongy mesophyll in the center. These cells are not tightly packed and have air spaces in between them. Water from the mesophyll cells evaporates into the air spaces. If water potential of air spaces inside the leaf is higher than the air outside water diffuses across the water potential gradient.

This loss of water mainly depends upon the opening and closing of stomata. Stomata are open when plants need CO2 for photosynthesis and closed when plants are not performing photosynthesis.

Thus, transpiration is mainly an inevitable consequence of gaseous exchange by plants. Although when plants need to conserve water they adapt various alternate ways for gaseous exchange minimizing transpiration.

This process of excretion of water in the form of water vapors is called transpiration.

Factors Affecting Rate Of Transpiration

Several factors affect the rate of transpiration.

Opening And Closing Of Stomata:

Plants have to regulate the opening and closing of stomata according to their need. Stomata serve as a passage for the diffusion of gases. Thus, when the plant is performing photosynthesis they need more CO2 during the daytime. So plants keep their stomata open. While at night when photosynthesis is stopped plants close their stomata.

This increased rate of transpiration during the daytime.

Light

Light increases the rate of photosynthesis thus it increases gaseous exchange. That means stomata will remain open and the rate of transpiration will be increased.

Humidity

The rate of transpiration will be increased in a less humid environment. This is because the water potential gradient between atmosphere and air inside leaf will be hight.

Wind Velocity

High wind velocity will also increase the rate of transpiration. That is because it distributes the water vapors present in the air creating a gradient.

Temperature

Transpiration is also increased by increasing temperature.

Investigating Factors Affecting Rate Of Transpiration:

It is difficult to measure the water loss from the leaf but it is easier to measure the water absorbed by the leaf. As the greater, the water absorbed by a plant the greater the amount of water will be a loss. Thus, we are assuming here that the amount of water absorbed is equal to the amount of water loss.

METHOD

The apparatus that is used to measure the absorption of water is called potometer. It consists of a glass tube.

Fix a rubber tubing over one end of a glass tube.
Submerge it completely in water.
Make sure there are no air bubbles in it.
Take a piece of the shoot and submerge it beside the glass tube. Cut the stem and push it in the rubber tubing.
Ensure that the shoot is fitted completely.
Take out the apparatus from water and wait for it to dry.
Attach a scale with the glass tube to measure the level of water.
Now take readings by noting the level of water every two minutes. Stop when you have collected ten readings.
Change the factors like increasing the speed of wind, light, temperature, etc. See their effect on the readings.

Transpiration As A Necessary Evil: 


Adaption In Xerophytic Plants:

Transpiration can be a problem for plants living in a xerophytic condition( dry). To counter this, they have developed many adaptations.

The surface area of leave is reduced by turning them into spikes.
Roots are well developed. There is a vast system of horizontal roots to absorb water.
The stem is succulent and filled with water.
Stomata are sunken.
The thick cuticle is present to prevent loss of water.

Movement Of Water From Xylem To Leaf:


Structure Of Xylem:

Xylem is a compound tissue that means it is made up of different cells.

Vessels

These are the lignin fortified cells that are responsible for the conduction of water. They are connected end to end with each other. When the cell wall is deposited with lignin the parenchyma of cell dies. Leaving behind a hollow structure. The cell wall between cells is dissolved making a continuous column for conduction of water.

Fibers

These are dead cells that are responsible for providing support to the plant.

Parenchyma Cells

Parenchyma cells are young plant cells with a thin cell wall. They have all the plant organelles.

Transport Of Water:

As said before the leaf is continuously losing water by transpiration. This reduces the hydrostatic pressure. While the xylem is continuously receiving water which increases the hydrostatic pressure. Thus, water is moved up from high pressure to low pressure. This is the same as sucking water from a straw. When you suck at the top the pressure is reduced creating a pressure difference. Due to which water moves up.

Movement of water in the xylem is mass flow. That is all the molecules move together in the form of liquid. There are two properties of water which aids in this.

Cohesion

Water molecules have an attraction between each other due to hydrogen bonding. This is called cohesion thus when one molecule moves up it takes another one as well.

Adhesion

Water molecules also have attracting forces between its molecule and xylem wall. Thus, it helps them in climbing up.

Phloem Translocation:

Movement of solutes in phloem is called translocation. These solutes are substances that are made by the plant itself during photosynthesis.

Structure Of Phloem

Phloem is associated with the transport of organic substances within plants.
It consists of:

Sieve element: These are cells that are connected end to end to make a continuous column. They have a very thin cytoplasm lying close to the cell wall and are associated with transport. The end of two sieve elements has a sieve plate. It has numerous gaps which allow transport.

Companion cells: these are normal plant cells with all the components. They lie close to sieve elements.

Mechanism Of Phloem Translocation:

The substances are pumped in phloem actively. Thus, phloem translocation is an active process as compared to water transport in xylem which was passive.

Phloem Loading

Mesophyll cells in the leaf produce carbohydrates by photosynthesis. These are moved into the companion cells and then into sieve elements by active transport. Due to the entry of solutes water potential is decreased.

Phloem Unloading

The solutes in the sieve element are then pumped into any cell which needs it. This is also an active process as the concentration of solutes is already higher in these cells. This active pumping increases the water potential.

Pressure Flow Hypothesis

The active phloem loading creates a negative water potential at that end of the sieve element. While the phloem unloading increases the water potential at the other end of the tube.

The decrease in water potential results in the entry of water from the xylem into the phloem. While on the other side water leaves the phloem due to an increase in water potential. This creates a pressure difference at both ends. Thus, water is moved from high pressure to low pressure. It can be concluded from here that phloem translocation is pressure driven.

© 2020 O’Level Academy. All Rights Reserved